Plastic Testing
Typical capacity : 5kN to 50kN
Tensile Test : ATSM D638, ASTM D882, ISO 527 etc
Flexural : ASTM D790, ISO 178 etc
Peeling : ASTM D1876, ISO 11339 etc
Compression : ASTM D575, ASTM D3574 etc
MFI
To measure flow rate of the plastic material, Mass flow rate, or volumetric flow rate
Standard : ASTM D1238, ISO R1133
HDT/VICAT TESTER
HDT
Essentially a three point bending test submerged in oil bath to determine the heat deflection temperature of plastic at 0.254mm deformation
Vicat
to determine the softening temperature of plastic when the needle penetrate by 1mm. The machine can automatically capture the temperature readout when the parameters were fulfilled.
TWO ROLL MILL AND HOT PRESS
Lab scale machinery to prodcue colour chip by mixing plastic resin with colour pigment.
Significantly reduce costly guessing game trying to fulfill customer desired colour.
REDUCE COST! Only a small volume of resin is required, compared to 10 to 100 hundredth kg for production extrusion mixing
IMPACT TESTER
SPECIMEN NOTCHING MACHINE
ASH CONTENT FURNACE
